Auto-Fresh Fountain Cleaning Instructions
You will need: #2 Phillips head screwdriver
STEP ONE
A) Remove battery –door cover
B) Locate the two screws that hold the Auto-Fresh Fountain housing together.
C) Gently pull up on the bottom half of the Auto-Fresh Fountain to expose the inside of the Auto-Fresh Fountain.
STEP TWO
A) Set aside the two black rubber o-rings that sit at the base of the springs.
B) Remove the water spigot from the front of the Auto-Fresh Fountain by pulling and gently twisting back and forth.
C) Remove the two screws that hold the screen to the front of the Auto-Fresh Fountain.
STEP THREE
A) Slide out the Auto-Fresh Fountain circuit board and the solenoid.
B) Remove the solenoid from the valve body by loosening the slot head screw at the end of the solenoid.
C) Remove the plunger from the inside of the solenoid. Inspect the solenoid for dirt, debris, or hard water build-up, and clean with a cotton swab if necessary. If you notice hard water build-up, a bit of vinegar will help remove it.
STEP FOUR
A) Re-assemble the Auto-Fresh Fountain by following these instructions in reverse. Remember to replace the two rubber o-rings.
For troubleshooting help with your fountain drinking water unit call the product support help line at 1-800-767-8658 M-F 8-4:30 Pacific. When you call, please provide the 4 digit code that is on a white sticker inside the battery compartment.
Power: 4 C-cell batteries (not included)
Battery power duration: Up to one year on a set of 4
Housing: High-quality UV resistant materials colored white to keep water cool, even on bright, sunny days
Sensor: Sonar proximity sensor detects your dog’s presence within a 40-degree angle in front of the unit, and up to three feet away, automatically shutting unit on and off as required.
Click below for cleaning instructions